Installing Vinyl Lettering

1. Rub your Squeegee or application stick Gently over the vinyl lettering or vinyl designs to make sure they will stick to the transfer tape.


2. Flip up the lettering (upside down) without removing it from the wall. Peel off the white backing slowly and carefully. Make sure all designs and lettering are sticking to the clear transfer tape!


3. Let the vinyl and clear transfer tape slowly fall back into place on your wall.


4. Using the edge of a squeegee, rub or application stick over the entire design again. Work from the center towards the edges to remove any air bubbles.


5. Slowly and carefully remove the clear transfer tape, beginning in the upper right corner and working at an angle. If any letters are difficult, just use your squeegee to help them transfer to the wall.